Energy

Energy Cost Scenario

Enter measured or user-supplied energy inputs. Rated nameplate watts alone cannot produce kWh — brew-cycle Wh is required when cycles > 0.

Change a value. Watch the output move.

Inputs

Brew cycles per day Brew cycle energy (Wh) Keep-warm events per day Keep-warm energy per event (Wh) Your keep-warm minutes per event Keep-warm test duration (min) Ready power (W) Ready hours per day Idle power (W) Idle hours per day Standby power (W) Standby hours per day Networked standby power (W) Networked standby hours per day Off power (W) Off hours per day Days used per year Electricity rate ($/kWh) Currency Measurement scope Energy evidence basis Range reason (required if range supplied) Range low daily kWh (optional) Range high daily kWh (optional)

Planning estimate only. Change inputs to match your situation.

Live output

Calculated, not measured. Based on the usage assumptions and energy inputs shown below using Formula coffee-energy-v1.0.0. Change the assumptions to match your use.

Daily kWh—

Annual kWh—

Annual cost—

Currency—

Annual kWh range—

Annual cost range—

Job this solves

Estimate daily and annual kWh and electricity cost from measured brew-cycle and state-power inputs.

Formula

coffee-energy-v1.0.0

Assumptions

Defaults are starting points, not recommendations. Outputs inherit your inputs.

Common questions

Is this measured energy use?

No. Results are calculated from the inputs you enter using formula coffee-energy-v1.0.0. Change assumptions to match your routine.

Can I use rated watts instead of brew-cycle Wh?

No. Nameplate rated input is not a substitute for measured brew-cycle energy when estimating kWh.

All tools · Guides · Machines